Word Up: DIY Letter Bobby Pins

❤️ By Jenn Shin

Dying to say something? Spell it out on a hair accessory!

What You’ll Need:

  • Bobby pins or hair clips
  • Thin cardboard
  • Nail polish
  • Alphabet pasta
  • Tweezers
  • Glue


What You’ll Do:

Slide your bobby pins onto the cardboard and paint them with nail polish. (We did two coats.) While those dry, find your pasta letters so they’re ready to go.


Add a small amount of glue to the back of each letter and apply the alphabet pasta with tweezers. Brush the letters with a thin coat of polish and touch up any spots on the pin.


Let everything set for a few hours… And that’s it! As Ina would say, how easy was that?



How to: Bleached Tie-Dye Jeans

So your absolute favorite jeans finally wore through the knee and got a mustard stain on them. Devastating, we know. But rather than toss them aside and mourn their loss, give your trusty jeans new life! Tie-dying jeans with bleach is a cinch, and it won’t even cost you a penny. You’ll likely have most of the supplies just sitting around your house. Bleach dying jeans also doesn’t have to be limited to worn out jeans. It’s perfect for jeans with a simple wash that just need a little more character. And the best part about this DIY is that no two pair will look alike! So pull out some grubby clothes you don’t mind getting messy, and get ready to get your craft on.

Our Finished Look.

Love the kicks? Get ’em here!

Here’s what you’ll need: Jeans, rubber or plastic gloves, a plastic bucket, rubber bands, bleach, and water/sink

Make knots in the jeans with the rubber bands. There is really no wrong way to do this, just use as many as you want. The thicker the rubber bands, the heavier the dark spots. If you want sparse spots, use less rubber bands. It’s up to you!

Place rubber bands all the way around your denim ball so it doesn’t open up during its bath.

Rinse your denim ball so it’s thoroughly wet. Then pour 50/50 bleach and water into a bucket.

Gently place your jeans into the bucket. If they aren’t covered, either pour in more water/bleach or rotate every few minutes.

Let jeans sit for 20-60 minutes depending on the thickness of the denim and the desired color. The longer you leave them, the lighter they’ll get.

Tip: Don’t leave jeans soaking for too long or the bleach will start to eat away at the fabric. Just keep an eye on them!

When jeans have lightened up sufficiently, rinse them out and remove the rubber bands.

Note: Jeans will also get lighter as they dry.

Ring out excess water, and let jeans hang to dry. You can make this process shorter by tossing them in the dryer after they’ve sat for a little while.

Pair you new jeans with you favorite kicks, and wear them everywhere!

Have you ever tried a makeover on your favorite jeans?

P.S. You can find the jeans we used for this DIY on the GoJane site.

Blog at WordPress.com.
The Esquire Theme.


Get every new post delivered to your Inbox.

Join 4,113 other followers

%d bloggers like this: